Influence of the Initial Microstructure on the Mechanical Behavior During Forming for Inline Manufacturing Process Routes

With a view of sustainability and the rising energy costs currently, manufacturing processes of metals are becoming increasingly focused on optimizing process parameters such as energy and time consumption. A conventional hot-forming process route currently involves casting an ingot, letting it cool down, and heating it up again for the hot-forming process (see Fig. 1a). In order to implement the combination of casting and forging, avoiding the reheating cycle and using less energy, by utilizing the casting heat (see Fig. 1b), a methodology was developed within the present work to quantify the influence of the resulting microstructure as a function of the cooling rate on the forming and recrystallization behavior (see Fig. 1c). For this purpose, AISI 301 austenitic stainless-steel cast samples with different cast cooling rates were generated. An in-situ high-temperature microscope is used to determine the holding time and the heating rate. Dilatometer tests are performed to characterize the interaction between initial microstructure and the flow curves to verify the determination method (see Fig. 1d). The aim was to demonstrate whether the microstructure evolution and mechanical behavior is affected by the initial microstructure. The flow curves and the post-forming microstructure show a higher degree of recrystallization in fast-cooled microstructure than slow-cooled microstructure. Hence, it was found that the initial microstructure and the associated temperature history does have an impact on the mechanical properties.     «

With a view of sustainability and the rising energy costs currently, manufacturing processes of metals are becoming increasingly focused on optimizing process parameters such as energy and time consumption. A conventional hot-forming process route currently involves casting an ingot, letting it cool down, and heating it up again for the hot-forming process (see Fig. 1a). In order to implement the combination of casting and forging, avoiding the reheating cycle and using less energy, by utilizing...     »