For experiments at the ultracold neutron (UCN) source of the new high-luminosity neutron source, Forschungsreaktor Mu. nchen II (FRM II), highly efficient detectors are needed. The desired type of detectors utilizes 6Li as the neutron converter based on the huge cross-section reaction 6Li(n,a)t and detection of the 2.06 MeV a-particles or the 2.73 MeV t-particles. The high reflectance of UCN from 6Li with its positive optical potential must be compensated by a material with negative optical potential. Instead of the expensive 62Ni material, natural Ti can be chosen. It was demonstrated that neither 6Li metal nor Ti metal can be deposited in a high-vacuum evaporation apparatus without creating a positive optical potential and thus increasing the reflectivity for the UCN due to oxygen impurities coming from the H2O partial pressure in the high-vacuum system. To overcome these problems, a new UHV evaporation apparatus was developed and built which is capable of reaching a vacuum in the 10À10 Pa range. Such a good vacuum can be obtained only when annealing the vacuum system up to 470 K. At such a high annealing temperature the silicon detectors for the a- and t particles might suffer degradation of their energy resolution. Therefore, the multi-layer system of 6Li and natTi is not deposited directly on the silicon detector but a thin rolled Ti foil is applied as backing. A test deposition of 200 double layers of 6LiF/62Ni on a thin Ti foil is described and a report is given about the setup of the new UHV evaporation apparatus.     «

For experiments at the ultracold neutron (UCN) source of the new high-luminosity neutron source, Forschungsreaktor Mu. nchen II (FRM II), highly efficient detectors are needed. The desired type of detectors utilizes 6Li as the neutron converter based on the huge cross-section reaction 6Li(n,a)t and detection of the 2.06 MeV a-particles or the 2.73 MeV t-particles. The high reflectance of UCN from 6Li with its positive optical potential must be compensated by a material with negative optical pote...     »